Login
Cart

Aero CV Boot for 6-Bolt Tripod Housing

Your Price: $54.65

Retail Price:$59.99

You Save:$5.34(9%)

Part Number: 99D2015

Availability: In Stock.

Quantity

Description

Low-profile, aerodynamic CV boot fits 6-bolt tripod joint housings:

Fits all common 26mm and 40mm wide tripod housings that are 94mm in diameter. Fits Van Diemen '94- current, Elan DP08, Citation, and Swift 016 among other formula and sports racer cars.
Holes accept up to an 8mm diameter bolt.
Half-shaft hole is 20mm in diameter, but easily stretches to 25mm
Rubber channel at the neck of the boot that is approximately 5.5mm wide for running a clamp or zip tie to further help seal the boot to the half-shaft for grease retention.
"Rough" edged seal on the half shaft to help keep tripod grease where it needs to stay...on the tripod and not leaking out.
Two small rubber channels on the inner side that seals against the half-shaft for putting a small piece of a spray can straw (like from WD-40) into the boot, often under the clamp. Acts as a simple vent to release built-up pressure from hot grease, preventing the boot from overinflating and bursting or tearing, especially during hard driving or racing. It lets the boot "breathe," stopping the grease from being forced out and protecting the joint from contamination
Thick steel base flange helps to retain the tripod joint in the housing.
The rubber boot is bonded to the steel flange via a vulcanization process that permanently fuses the rubber to steel through a multi-step process of surface preparation (cleaning, etching, and blasting), application of primers and bonding agents, and then molding and curing the rubber to the prepared steel under heat and pressure. It might not be the most beautiful part on your car, but this method creates a strong, durable, one-piece component that combines the flexibility of rubber with the rigidity of steel, resulting in a CV boot with enhanced performance and longevity for racing applications.
Used with 26mm thick Tripod Housing and 40mm thick Tripod Housing that often uses the 30-spline tripod joint.
Part 99D2015.

54.65 points will be rewarded to you when you buy this item.

GKN Style 94mm O.D. Size 10 CV Joint, 6 x 78mm Bolt Circle, 33 Spline

GKN Style 94mm O.D. Size 10 CV Joint, 6 x 78mm Bolt Circle, 33 Spline

$109.65

In Stock.

Rear Drive Flange, Van Diemen '99-current & DP-08

Rear Drive Flange, Van Diemen '99-current & DP-08

$159.00

In Stock.

Driveshaft Abutment, Outboard, Van Diemen & DP-08 '99-Current

Driveshaft Abutment, Outboard, Van Diemen & DP-08 '99-Current

$21.50

In Stock.

GKN Convoluted CV boot for 94 mm cv joint 78mm bolt circle Dia.

GKN Convoluted CV boot for 94 mm cv joint 78mm bolt circle Dia.

$16.99

In Stock.

aluminum d/shaft plunger for 94-96

aluminum d/shaft plunger for 94-96

$21.81

In Stock.

40 MM wide tripod housing (steel)

40 MM wide tripod housing (steel)

$175.00

In Stock.

GKN Lightened & Honed HD Loebro CV Joint, 6 x 94mm BC, 28 Spline 108MM O.D.

GKN Lightened & Honed HD Loebro CV Joint, 6 x 94mm BC, 28 Spline 108MM O.D.

$239.99

Back Order.

Tripod Joint for F4 and USF-GKN style GI3300I 26-Spline

Tripod Joint for F4 and USF-GKN style GI3300I 26-Spline

$46.59

In Stock.

STAY UP TO SPEED