Login
Cart
Brand: Campbell Motorsport
If you spend too much time trying to bed your brake pads, consider replacing your worn, grooved rotors! Our brake rotors are brand-new castings made in the USA exclusively for racing use. They are not repackaged street car rotors. Sold individually. This rotor is the same as our 3545-29, but grooved and lightened. This size fits the front and rear of Swift DB-2 (S2) and DB-3 (FC) with LD20 calipers. Note that some DB-3 cars were fitted with smaller calipers and should use the slightly smaller Brake Rotor for Swift DB-3 with LD19 Calipers(Part No.60- 3545-11).
*Height is measured from the inner friction surface to the outer face of the hat. Place the rotor down on a table and measure from the table surface to the highest point on the hat.